Manual

THE PUSH ON/OFF PURGE
SYSTEM (POPS)
Having disconnected the Macroline hose from the fitting
on the POPS body, fully depress the Latch Button then
slide the bonnet forward while continuing to depress
Latch Button
(SEE FIGURE 26A).
When the bonnet is in the forward position
(SEE
FIGURE 26B)
remove the Latch Button and Spring
from the bonnet
(SEE FIGURE 26C) then slide the
bonnet off the POPS body
(SEE FIGURE 26D). Be
careful not to lose the spring.
Carefully slide the Push Rod out from either side of the
POPS body, taking care not to lose the two o-rings on
the Push Rod
(SEE FIGURE 26E).
Clean off any dirt, debris or moisture from the bonnet,
the POPS body and the Latch Button
(SEE FIGURE
26F)
.
Remove the POPS Insert Assembly using a 5/32” hex
key
(SEE FIGURE 26G). Remove the POPS Pin from
the POPS Insert.
Clean and check the condition of the 007 NBR70
o-ring on the outside of the POPS Insert, replacing as
necessary
(SEE FIGURE 26H).
FIG 26b
FIG 26D
FIG 26F
FIG 26h
FIG 26A
FIG 26C
FIG 26E
FIG 26G
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
69.
Maintenance
QUICK GUIDE