Manual

(CONTINUED)
Position the trigger so that the hole through the trigger
lines up with the holes in the bearing carrier, slide the
trigger pin into place
(SEE FIGURE 25G).
Gently lower the trigger assembly and bearing carrier
into the frame, taking care not to damage the Micro-
switch or the Opto sensor, and ensuring that the trigger
is positioned correctly
(SEE FIGURE 25H).
Using a 5/64” hex key screw the right side M2.5x5
retaining screw into place but do not fully tighten it into
place
(see Figure 25I).
Ensure the trigger moves freely within the frame, then
using a 1/16” hex key tighten down the trigger pin
retaining set screw.
Place the trigger spring over the bearing carrier in its
designated groove, align the hole in the trigger spring
with the front/left hole in the bearing carrier, then screw
the retaining screw into the frame. Tighten both screws
with a 5/64” hex key
(see Figure 21J).
DO NOT overtighten the retaining screws. Doing so may
damage the trigger spring and threads in the frame.
You have now stripped and cleaned your Geo3 trigger
Assembly.
FIG 25G
FIG 25h
FIG 25I
FIG 25J
WARNING: IF YOU ARE AT ALL UNSURE AT
PERFORMING THE MAINTENANCE PROCEDURE
PLEASE CONTACT YOUR NEAREST ECLIPSE SERVICE
CENTRE. (SEE PAGE 75)
WARNING
68.
MAINTENANCE