Manual

THE GEO3 TRIGGER
ASSEMBLY
Having removed the frame completely from the Geo3
body (see page 61). Unscrew the two M2.5x5 retaining
screws which hold the bearing carrier in the frame.
(SEE FIGURE 25A).
Remove the trigger spring from the bearing carrier,
(SEE FIGURE 25B).
Gently lift the bearing carrier and trigger assembly free
from the frame taking care not to damage the Micro-
switch or the Opto sensors
(SEE FIGURE 25C).
Using a 1/16” hex key, loosen the trigger pin retaining
set screw from the back of the trigger
(SEE FIGURE
25D)
.
Use a small hex key to push the trigger pin out of the
bearing carrier from one side
(SEE FIGURE 25E),
then remove the bearing carrier from the trigger
(See
Figure 25F)
.
Clean the trigger, trigger spring and bearing carrier
thoroughly and also clean the space within the frame
that the trigger sits in.
FIG 25A
FIG 25b
FIG 25D
FIG 25F
FIG 25C
FIG 25E
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
67.
Maintenance
QUICK GUIDE