Manual

(CONTINUED)
Lastly inspect and clean the large solenoid gasket,
replacing if damaged
(see figure 24M).
Apply a small amount of grease to the outer most
groove surrounding the Solenoid Manifold pocket in
the Geo3 body. Then making sure the top Solenoid
Manifold gasket lies flat in the Solenoid Manifold, insert
the Solenoid Manifold back into the Geo3 body
(see
figure 24N)
.
Next place the solenoid gasket over the Solenoid
Manifold ensuring that the gasket is secure in its groove
in the Geo3 body
(see figure 24O). Make sure that
the Bottom Solenoid Manifold gasket is flat in its groove
in the Solenoid Manifold.
Place the Solenoid Valve over the Solenoid Manifold
(see figure 24P), making sure the location holes
line up with the threads in the Geo3 body
(see figure
24Q)
.
Replace the retaining screws which hold the solenoid
onto the Geo3 using a 5/64” hex key
(see figure
24R)
. DO NOT over tighten screws in the Solenoid
Assembly.
Maintenance of the solenoid assembly is complete
FIG 24M
FIG 24O
FIG 24Q
FIG 24N
FIG 24P
FIG 24R
WARNING: IF YOU ARE AT ALL UNSURE AT
PERFORMING THE MAINTENANCE PROCEDURE
PLEASE CONTACT YOUR NEAREST ECLIPSE SERVICE
CENTRE. (SEE PAGE 75)
WARNING
66.
MAINTENANCE