Manual

THE GEO3 SOLENOID
ASSEMBLY
***IMPORTANT***
The Geo3 solenoid assembly contains two sub-
assemblies, the Solenoid Valve and the Solenoid
Solenoid Manifold. Removal of the Solenoid Valve is
required to access the Solenoid Manifold for servicing.
The SOLENOID VALVE itself
(highlighted in figure
24A)
is a NON-SERVICEABLE item. Any attempt to
strip or service the Solenoid Valve will immediately
void the Geo3 warranty. If you experience any issue
with the Geo3 Solenoid Valve then please contact your
Eclipse Service Centre. See page 75 for Eclipse Service
Centre details.
With the frame separated from the Geo3 body and the
solenoid and BBSS wires unplugged from the Circuit
Board (see page 61) use a 5/64” hex key to undo and
remove the two screws that hold the solenoid assembly
onto the Geo3 body
(SEE FIGURE 24B). Firstly
remove the Solenoid Valve from the body, this will
expose the Solenoid Manifold which sits partially inside
the Geo3 body
(see figure 24C).
Carefully pull the Solenoid Manifold out from the Geo3
body, exposing the gas transfer holes which lead to the
bolt assembly
(see figure 24D). The solenoid gasket
may still be attached to the body, if this is the case,
carefully peel the gasket off the body and place to one
side.
With the solenoid assembly completely removed from
the Geo3 body the bottom of the Geo3 body should
now resemble
FIGURE 24E. Ensure that the air
transfer holes in the bottom of the body are free from
contamination from any dirt, debris, paint or moisture
and clear away any excess grease if it appears to be
blocking any of the transfer holes.
FIG 24b
FIG 24D
FIG 24F
FIG 24A
FIG 24C
FIG 24E
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
64.
MAINTENANCE