Manual

ADVANCED BOLT SYSTEM
MAINTENANCE
This procedure is only required if you are maintaining
the rear prop shaft 14x2 o-ring, which if damaged or
dirty will cause a leak around the back cap of the Geo3.
Insert an appropriately sized hex key or screw driver
shaft into the hole in the middle of the prop shaft, take
a 1/8” hex key and remove the retaining screw in the
back of the prop shaft
(SEE FIGURE 21A). Remove
the prop shaft from the back cap, taking care not to
lose the prop shaft spring. Check the 14x2 o-ring at
the back of the prop shaft, and clean or replace then
re-lubricate with Eclipse Grease as necessary
(SEE
FIGURE 21B)
.
Check the rear bumper for signs of wear, replace as
necessary then re-install the spring
(SEE FIGURE
21C)
. Replace the back cap over the rear of the prop
shaft, then replace the retaining screw using a 1/8” hex
key to reassemble to prop shaft
(SEE FIGURES 21D
& 21E)
.
1
1
If any o-rings or the bumper are damaged then replace them. Extra
o-rings and bumpers are available in parts kits available at
www.planeteclipse.com
FIG 21A
F IG 21b
F IG 21D
F IG 21C
F IG 21E
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
60.
MAINTENANCE