Manual

SWITCHING ON THE GEO3
To switch on the Geo3 press the button twice in quick
succession, referred to elsewhere in this manual as
‘double-clicking’. The Geo3 can also be switched on by
pushing and holding the
button (figure 1A).
1
SWITCHING OFF THE GEO3
Press and hold the button until the display shows
“TURN OFF”. Release the
button and re-press it
to turn off the Geo3. Alternatively double click the
button to enter the menu tree then press
to turn off
the Geo3.
1
FIRING THE GEO3
Pull the trigger to fire the Geo3. The entire firing
sequence is controlled electronically by the Geo3 circuit
board, enabling any user to easily achieve high rates of
fire.
THE GEO3 CIRCUIT BOARD
There are four sockets on the circuit board; the Break
Beam Sensor System (BBSS) socket
A
, the Solenoid
Valve socket
B
, the auxiliary socket (to which third
party products such as loaders and RF transmitters can be
connected using the relevant wiring harness)
C
and the
Expansion Board socket on the back of the circuit board
(which connects the Eclipse E-Portal USB Daughter
Board to the Geo3)
D
(See Figure 1B).
2,3
1
The double clicking feature is user selectable, factory default is set
to on. It can be turned off using the double click parameter in the
Hardware menu (see page 49).
2
The auxiliary socket is turned on and off manually via the AUX OUT
parameter in the Hardware menu on page 49.
3
Eclipse E-Portal sold separately (see page 81).
C
A
B
D
F IG 1b
FIG 1A
6.
QUICK SET-UP