Manual

CLEANING THE BODY FILTER
Remove the inline regulator as covered on page 54. Turn
the Geo3 upside down to reveal the body filter inside
the body
(See Figure 19A).
Using a 5/64” hex key unscrew and remove the
retaining screw
(See Figure 19B).
Then remove the body filter
(See Figure 19C).
Inspect and clean the body filter. If the filter is very
dirty replace with a new filter.
Insert the filter into the FRM on the Geo3 body,
ensuring the hole in the filter lines up with the threads
in the body
(See Figure 19D).
Using a 5/64” hex key, replace the retaining screw. DO
NOT over tighten the retaining screw as this may result
in the filter being crushed between the screw and Geo3
body
(See Figure 19E).
Re-attach the inline regulator to the Geo3.
If after cleaning the Geo3 is still experiencing slow purge and low
velocity issues the filter may need replacing.
F IG 19b
F IG 19D F IG 19E
F IG 19A
F IG 19C
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
WARNING: IF YOU ARE AT ALL UNSURE AT
PERFORMING THE MAINTENANCE PROCEDURE
PLEASE CONTACT YOUR NEAREST ECLIPSE SERVICE
CENTRE. (SEE PAGE 75)
WARNING
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
57.
Maintenance
QUICK GUIDE