Manual

(CONTINUED)
Remove the rubber Detent and using a dry cotton bud
clean the Detent and its location point in the Geo3 body,
replacing the Detent if it is damaged
(See Figure
16D)
. Reinsert the Detent back into the Geo3 body
and place the BBSS back into the designated slot in
the body
(See Figure 16E). Ensure that the sensor is
face down in the body i.e. looking into the breech.
1
Replace the eye cover and using a 5/64" hex key, replace
the Bream Beam Eye cover retaining screw to hold the
eye cover in place
(See Figure 16F).
Repeat the procedure for the opposite side of the Geo3.
You have now cleaned your Break Beam Sensor System.
1
Ensure that the receiver sensor (indicated by a red mark & red heat
shrink) is located on the right-hand side of the marker body.
F IG 16 D
F IG 16 E
F IG 16 F
WARNING: IF YOU ARE AT ALL UNSURE AT
PERFORMING THE MAINTENANCE PROCEDURE
PLEASE CONTACT YOUR NEAREST ECLIPSE SERVICE
CENTRE. (SEE PAGE 75)
WARNING
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
53.
Maintenance
QUICK GUIDE