Manual

CLEANING THE BREAK BEAM
SENSOR SYSTEM
Undo the retaining screw for the Break Beam Eye cover
on the left hand side of the Geo3 using a 5/64" (2mm)
hex key
(See Figure 16A).
Remove the eye cover to expose the back of the Break
Beam Sensor unit
(See Figure 16B). Using a dry cotton
bud, carefully remove any debris, paint or moisture from
the back of the sensor unit and from inside the eye cover.
Lift the Break Beam Sensor unit free from the Geo3
body and using another dry cotton bud, remove any
grease or debris build-up from the front of the sensor
unit
(See Figure 16C).
F IG 16 A
F IG 16 b
F IG 16 C
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
WARNING
52.
MAINTENANCE