Manual

TRAINING
THE TRAINING PARAMETER
The TRAINING parameter is used to select
Training mode. In Training mode the Geo3
will function exactly the same as normal
but with two important differences:
1. The solenoid valve is not driven so the
Bolt does not move and does not release a
burst of air. Instead the beeper will sound
for each pull of the Trigger. This simulates
the firing cycle without wasting air and generating lots
of noise.
2. The BBSS is overridden so that the Geo3 can
cycle without paint. The centre of the BBSS indicator
changes to a ‘T’ to indicate that Training mode is
enabled. The TRAINING parameter choices are as
follows:
> OFF: Training mode is disabled and the Geo3
functions normally.
> ON: Training mode is enabled.
> CANCEL: Cancel editing and leave the parameter
unchanged.
SHOT COUNT
THE SHOT COUNT MENU
The SHOT COUNT menu allows the user to alter the
shot gauge that appears in the shot count Run Screen.
GAUGE
THE GAUGE PARAMETER
The GAUGE parameter allows the user to
toggle the gauge graphic on and off, in
the shot counter Run Screen. The choices
for the GAUGE parameter are:
>OFF: Gauge graphic on the shot count
run screen is disabled.
> ON: Gauge graphic on the shot count
run screen is enabled.
> CANCEL: Cancel editing and leave the parameter
unchanged.
GAUGE MAX
THE GAUGE MAX PARAMETER
The GAUGE MAX parameter allows the
user to set the number the gauge counts
down from every time the Geo3 is fired.
The user can set the gauge from 100 to
2000 in increments of 10.
50.
ADVANCED SET-UP