Manual

FULL
THE BREECH FULL TIME PARAMETER
Tumbling paintballs can take time to
settle in the breech before they can be
successfully fired. This parameter is used
to set the amount of time that a paintball
has to be in the breech before the Geo3
is allowed to fire. This parameter can be
set between 1.0 and 20 milliseconds in
0.1ms increments.
PULL TM
THE TRIGGER PULL TIME PARAMETER
The PULL TM parameter is used to set the
minimum amount of time that the Trigger
must be pulled before it is recognised as
a valid trigger pull. This parameter can be
set between 3.0 and 20.0 milliseconds in
0.1ms increments.
RELEASE TM
THE TRIGGER RELEASE TIME PARAMETER
The RELEASE TM parameter is used to
set the minimum amount of time that
the Trigger must be released before it is
recognised as a valid trigger release. This
parameter can be set between 3.0 and
25.0 milliseconds in 0.1ms increments
increments.
PULL PT
THE TRIGGER PULL POINT PARAMETER
The PULL PT parameter is only available
if
OPTO has been selected in the
HARDWARE menu. PULL PT defines the
point at which the Trigger is considered
pulled and is adjustable between 51% and
99% in 1% increments.
RELEASE PT
THE TRIGGER RELEASE POINT PARAMETER
The RELEASE PT parameter is only
available if OPTO has been selected
in the HARDWARE menu. RELEASE PT
defines the point at which the Trigger is
considered released and is adjustable
between 1% and 49% in 1% increments.
BASIC TRIGGER
FILTER SET-UP
95% of Trigger bounce problems can be eliminated
by utilizing one of the nine fixed DEBOUNCE
choices
(LEVEL 1-9). In attempting to eliminate Trigger
bounce it is advisable to try the nine fixed DEBOUNCE
choices before attempting any advanced set up of the
Trigger filters.
46.
ADVANCED SET-UP