Manual

FIRE MODE
THE FIRING MODE PARAMETER
This parameter is used to select the firing
mode of the Geo3 and has the following
choices:
> SEMI:
This is the default and in this
firing mode the Geo3 will fire one shot for
every trigger pull.
> RAMP: In this firing mode, the rate of
fire is increased above the rate at which the trigger
is pulled once certain criteria have been met. These
criteria are set by the parameters on the RAMP SETUP
menu.
1
> CANCEL: Editing is cancelled and the parameter is
unchanged.
ROF CAP
THE RATE OF FIRE CAP PARAMETER
The ROF CAP parameter is used to specify
whether or not the Geo3 should have
a limited, or capped rate of fire. When
the ROF CAP is enabled, the maximum
achievable rate of fire is set by the BS ON
ROF parameter. Choices for the ROF CAP
parameter are:
> OFF: Rate of fire only limited by the
loader.
> ON: Rate of fire limited to the BS ON ROF parameter
value.
> CANCEL: Cancel editing and leave the parameter
unchanged.
1
Some presets and fire modes may only be available in certain
countries and on some models of the Geo3.
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
41.
Advanced Set-up
QUICK GUIDE