Manual

THE LOCK INDICATOR
The Geo3 has a tournament lock which prevents the
user from making changes to any parameter that
affects the way in which the Geo3 shoots, without the
need for tools. This feature is necessary in order to
make the Geo3 legal for tournament play.
When the lock is enabled the lock indictor will show a
closed padlock
.
When the lock is disabled the lock indictor will show
an open padlock
.
To enable or disable the tournament lock see
Accessing the Menu System on page 38.
THE BATTERY LEVEL
INDICATOR
The battery level indicator is used to show the state
of the battery within the Geo3. When the battery is
fresh the indicator will show a ‘full’ battery
and as
the battery is drained, so will the indicator show the
battery emptying. When the battery reaches a point
at which the Geo3 will no longer function reliably, the
indicator will start to flash. At this point the battery
must be changed immediately.
As well as displaying the voltage level of the battery,
the indicator also warns if the battery being used has
an incorrect voltage to operate the electronics reliably.
The icon for a battery with an incorrect voltage
output is
. If this icon is shown the battery must be
replaced immediately.
THE GAME TIMER
When the game timer is shown on the run screen then
it can be started by pressing the
button and the
timer will start to count down. The game timer can
also be configured to start on a trigger press with the
START
parameter (see page 51).
When the game timer reaches the
ALARM TIME the gamer timer will
start to flash and the audible alarm
will sound every second, provided
that the SOUND parameter is on.
When the game timer reaches
00:00, GAME OVER will be displayed
and the audible alarm will sound
continually, provided that the SOUND
parameter is set to ‘ON’.
To stop the game timer at any time
press and hold the
button for 0.5
seconds.
To reset the game timer to it’s preset
start time, push and hold the
button for 0.5 second.
The game timer will also be reset whenever the Geo3
is switched off.
THE SHOT
COUNTER
The shot counter will increment
every time that the circuit board
registers a trigger pull, regardless
of whether the shot counter is
displayed or not. When the shot
counter is displayed on the run
screen it can be reset to 0 by
pressing and holding the
button
for 0.5 seconds.
There is also an optional shot gauge
that can be displayed on this run
screen. The gauge counts down from
a user adjustable number. To alter
the gauge settings see page 50. The gauge is reset
whenever the Geo3 is switched off or the
button is
pressed.
32.
USING ThE GEO3