Manual

THE SOUND INDICATOR
The sound indicator on the run screen is used to
convey if the Sound parameter in the Hardware menu
(page 48) is switched on or off.
There are two possible conditions that can be
indicated:
In order for the trigger to be successfully operated
it must first be released and then pulled. The trigger
detection indicator (TDI) is used to indicate each of
the possible trigger states.
From the factory the Geo3 will have the Opto sensor
enabled. The micro-switch can be enabled from the
Hardware menu (see page 47).
THE TRIGGER DETECTION
INDICATOR (TDI)
SOUND ENABLED
The SOUND parameter is enabled. The Geo3
will make sounds when switched on and off
and when the game timer alarms or times out.
SOUND DISABLED
The SOUND parameter is disabled. The Geo3
will not make any sounds.
MICRO-SWITCH SELECTED, NOT ACTUATED
The Geo3 is configured to use the micro-
switch to detect trigger pulls. The micro-
switch is not currently actuated, i.e. the
trigger is released.
MICRO-SWITCH SELECTED, ACTUATED
The Geo3 is configured to use the micro-
switch to detect trigger pulls. The micro-
switch is currently actuated, i.e. the trigger
is pulled.
OPTO SENSOR SELECTED, READING ABOVE
PULL POINT
The Geo3 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading above the Opto
pull point, i.e. the trigger is considered
‘pulled’.
OPTO SENSOR SELECTED, READING 0%
The Geo3 is configured to use the Opto sensor
to detect trigger pulls. The Opto sensor is
currently reading 0%, i.e. the trigger is fully
released.
OPTO SENSOR SELECTED, READING 100%
The Geo3 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading 100%, i.e. the
trigger is fully depressed.
OPTO SENSOR SELECTED, READING BELOW
RELEASE POINT
The Geo3 is configured to use the Opto sensor
to detect trigger pulls. The Opto sensor is
currently reading below the Opto release
point, i.e. the trigger is considered ‘released’.
OPTO SENSOR SELECTED, READING
MID-RANGE
The Geo3 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading somewhere
between the Opto release point and the
Opto pull point, i.e. the trigger is half
depressed.
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
31.
Using the Geo3
QUICK GUIDE