Manual

UNLOADING THE GEO3
Securely attach a barrel blocking device such as the
Eclipse Barrel Sock
1
(supplied with the Geo3) to the
marker as shown in
Figure 14A.
Turn off the Geo3 electronics by holding down the
button on the back of the frame. When the screen
turns off and the marker speaker emits the ‘off’ tone
(if the Sound parameter is enabled), the marker has
been turned off
(See figure 14B).
With the Geo3 pointing away from you. De-gas the
marker by depressing the POPS latch button allowing
the bonnet to slide forward and vent air. Only when the
POPS has fully degassed the Geo3 marker, unscrew
and remove the air system.
(see figure 14C).
Open the clamping lever on the feed tube and slacken
off the sprocket screw if necessary on the feed tube.
Carefully pull the loader out of the feed tube
(see
figure 14D)
.
Looking down the feed tube, check to see if there are
any paintballs still in the breech, if there are, turn
the marker upside down while still keeping the barrel
facing away from any persons within firing range then
tip out any paintballs within the breech
(see figure
14E)
.
Next remove the barrel blocking device, and unscrew
the barrel
(see figure 14F). Remove any paintballs
within the barrel.
The Eclipse Geo3 has now been unloaded and is ready
for storage.
1
Instruction on using the Eclipse Barrel Sock can be found on the
Eclipse Barrel Sock warning label.
ALWAYS KEEP THE ECLIPSE GEO3 POINTED IN
A SAFE DIRECTION AND ENSURE ALL PERSONS
WITHIN RANGE CONTINUE TO WEAR FACE
PROTECTION, UNTIL MARKER IS COMPLETELY
UNLOADED AND SAFE.
WARNING
FIG 14 A FIG 14b
FIG 14C
FIG 14E
FIG 14D
FIG 14F
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
27.
Using the Geo3
QUICK GUIDE