Manual

ADJUSTING THE VELOCITY
When using your Geo3, you may wish to change the
velocity at which your Geo3 is firing. This is done by
inserting a 1/8" hex key into the adjuster screw at the
bottom of your Geo3 inline regulator and adjusting
it accordingly
(See Figure 12A). By turning this
adjuster screw clockwise you decrease the output
pressure of the inline regulator and consequently the
velocity, by turning the adjuster screw counter clockwise
you increase the output pressure of the inline regulator
and consequently the velocity. On the bottom of the
inline regulator there are engraved arrows to illustrate
which direction to turn the hex key to make the relevant
adjustment.
1
1
After each adjustment fire two clearing shots to gain an accurate
velocity reading. Never exceed 300fps.
F IG 12 A
THE INLINE REGULATOR OUTPUT PRESSURE AND
SOLENOID FLOW RESTRICTOR SETTING MUST BE SET/
CHECKED EVERY TIME MARKER IS USED. USING A
CHRONOGRAPH TO MEASURE THE FIRING VELOCITY OF
THE MARKER.
THIS WILL ENSURE THE MARKER IS FIRING AT A SAFE,
LEGAL VELOCITY EVERYTIME IT IS USED.
WARNING
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
25.
Using the Geo3
QUICK GUIDE