Manual

(CONTINUED)
The Micro-switch Activation screw is used to adjust
the point in the trigger pull at which the Micro-switch
is activated. Turn the screw clockwise to decrease the
amount of trigger travel to the activation point. Turn
the screw counter clockwise to increase the amount
of trigger travel to the activation point
(See Figure
11D)
.
The Spring Return Strength screw is used to adjust the
spring strength that returns the trigger to its resting
position. Turn the screw clockwise to increase the
amount of spring return strength in the trigger pull.
Turn this screw counter clockwise to reduce the amount
of spring return strength in the trigger pull. Do not turn
the screw too far counter clockwise or there will not be
enough force to return the trigger consistently
(SEE
FIGURE 11E)
.
When setting the trigger it is important to ensure that
the electronic trigger detection is working correctly.
When the trigger is fully depressed the Trigger Detection
Indicator (TDI) should point upwards
. When
the trigger is fully released the TDI should point
downwards
.
For more information, see understanding the Trigger
Detection Indicator (TDI) on page 31 and The Filter
menu on pages 45-47.
Figure 11F Key
Trigger spring
Spring Return Strength screw
Trigger Pin Retaining screw
Front Stop screw
Magnet Return Strength screw
Micro Switch Activation screw
Rear Stop screw
B
A
C
D
E
F
G
F I G 11D
F I G 11E
F I G 11F
C
D
E
F
G
B
A
24.
USING ThE GEO3