Manual

ATTACHING A LOADER
Using a 5/32” hex key or your fingers, turn the sprocket
screw of the clamping feed tube counter clockwise
(see
figure 10A).
Release the clamping lever on the feed tube
(see
figure 10B)
and test to see if your loader can easily
be pushed into the top of the feed tube. If the loader
cannot easily be pushed into the feed tube, loosen the
sprocket screw of the clamping feed tube a little more
by turning it counter clockwise using a 5/32” hex key or
your fingers
(see figure 10A).
When you have managed to push your loader into the
clamping feed tube, close the clamp to secure it firmly
in place
(see figure 10C). If the loader is loose then
you will need to release the clamp, tighten the sprocket
screw slightly by turning it clockwise with a 5/32” hex
key or your fingers and close the clamp. Repeat this
process as necessary to secure your loader in place.
You have now attached a loader to your Geo3. Once
you have filled your loader and air tank you will then be
ready to begin using your Geo3.
F IG 10 A
F IG 10b
F IG 10C
WARNING: DO NOT OVER TIGHTEN THE
CLAMPING FEED TUBE AS THIS MAY DAMAGE THE
LOADER OR FEED TUBE ITSELF.
WARNING
22.
USING ThE GEO3