Manual

STRAIGHT HOSE FITTINGS
The 10-32UNF macroline fittings found on the Geo3
(SEE FIGURE 8A &8B) DO NOT require thread
lock or tape to secure them on the marker. These are
secured by the capture o-ring on the end of the fitting.
Only use a 3/32” hex key in the designated hole inside
the fitting to remove or re-attach the fitting
(SEE
FIGURE 8C)
. When re-attaching the fittings DO NOT
apply too much force or the threads on the fitting/
receiving part may be damaged (remember to stop
when you meet resistance).
MACROLINE HOSE
To aid the longevity of your macroline hosing, it is
very important to remove it from and install it back
into the fittings in the correct manner:
Pull back the collet section of the hose fitting and
keep the collet depressed. Pull the macroline hose out
of the hose fitting and release the collet.
Before installing the macroline hose into the fitting
ensure that the end has been trimmed correctly and
is the correct length to ensure a tight fit in the hose
fitting.
IF THE MACROLINE BECOMES WORN, DAMAGED
OR IS THE WRONG LENGTH, REPLACE IT
IMMEDIATELY.
REPLACE THE MACROLINE HOSE WITH THE
FOLLOWING GRADE OR HIGHER -
1/4” OD X 1/8”ID SEMI RIGID NYLON 11
IF UNSURE CONTACT YOUR NEAREST ECLIPSE
SERVICE CENTRE
FIG 8A
FIG 8b
FIG 8C
WARNING
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
19.
Using the Geo3
QUICK GUIDE