Manual

ECLIPSE SHAFT4 BARREL
The Eclipse Geo3 comes as standard with an Eclipse Shaft4 barrel.
1,4
The barrel screws into the body of the Geo3 using a right hand thread meaning
that if you hold the Geo3 pointing away from you the barrel screws into the body in a
counter-clockwise direction.
2
The barrel comprises of two parts, a barrel back
A
and a barrel front
B
. The two
parts are joined together with a
left hand thread meaning that if you hold the
barrel, with the back nearest you, the front unscrews in a counter-clockwise direction.
The bore size of the barrel back is engraved at the end of the barrel back
C
.
3
On the barrel back there is a 016 NBR 70 o-ring
D
which prevents the barrel from
vibrating loose from the Geo3 body when the marker is fired. There is also a 015 NBR
70 o-ring on the tip of the barrel back
E
helps with alignment when the two sections
are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
1
The bore size of your Shaft4 may vary according to the
model of Geo3 you have.
2
The Geo3 will only accept COCKER threaded barrels.
Do not use any other type of barrel thread.
3
The Eclipse Shaft4 front and back barrel sections are
not interchangeable with older version shaft front and
back barrel sections (including Shaft3 barrel kits).
4
The model of barrel accompanying your Geo3 may
differ from described.
A
B
D
E
C
Contents
Orientation
Quick Set-up
Using the Geo3
Menu Tree
Advanced Set-up
Maintenance
Fault Finding
Service Centres
Parts List
Spares
Index
11.
Orientation
QUICK GUIDE