Manual

GEO3.5 MANUAL 9
WARNING!
The Geo3.5 may still re even if there is no paintball in the breech. Always
ensure all safety guidelines are followed when the Geo3.5 is switched on.
WARNING
USING THE BREAK BEAM
SENSOR SYSTEM
1 When the GEO3.5 is turned on, the BBSS is automatically enabled.
The Break Beam Sensor System, referred to elsewhere in this manual as ‘BBSS’
is used to detect when a paintball is ready to be red from the GEO3.5. If no
paintball is ready then the BBSS will inhibit the GEO3.5 from ring. This prevents
the GEO3.5 from “chopping” paintballs that are not fully loaded into the marker.
1
To switch off the BBSS, press and hold the button for 0.5 seconds (see
gure 4A). The BBSS indicator on the top right of the LCD will change from
(enabled) to (disabled).
To switch the BBSS back on, press and hold the button for 0.5 seconds.
The indicator will change back to .
When the BBSS is enabled, the indicator will change depending upon whether
the system has detected a ball or not. When no ball has been detected the
indicator will look like this . When a ball has been detected the icon changes to
look like this .
Additional features of the GEO3.5’s Break Beam Sensor System are covered in
full on page 23 of this operators manual.
FIG 4A