Manual

GEO3.5 MANUAL 65
The fault nding guide covers common symptoms, causes and solutions that are
likely to be encountered by the average user. If a issue with the GEO3.5 cannot
be solved using the fault nding guide, contact your nearest Eclipse Service
Centre for assistance.
SYMPTOM POSSIBLE CAUSE SOLUTION
GEO3.5 trigger is very “bouncy” Incorrect lter settings
Check that your trigger lter and de-bounce settings
suit your trigger set-up
The break beam sensor system does not appear to
be reading correctly
The break beam sensor system is dirty Clean the break beam sensor system
The break beam sensor system is not reading at all
The break beam sensors are the wrong way around
Check that the red receiver is on the right-hand side
of the breech
There is a broken wire or contact, or a short circuit
on either of the break beam sensor cables
Check the plug on the cables
Check for cuts or pinches in the sensor cables
Either break beam sensor is back to front
Check that the sensors face each other when
installed
Two or more balls are being fed into the breech
The rubber detents are broken / missing Change the rubber nger detents
Loader feed force is set too high Reduce the feed force on the loader
The break beam sensor system turns itself off after
ring
The eye is dirty Clean the eyes
The eye is faulty Replace the eyes
The eye is out of place Re-install the eyes then check the alignment
When the GEO3.5 powers up, the right hand side
of the screen is not displayed and the marker will
not re
The trigger is permanently depressed
Adjust the trigger until the selected trigger detection
method is activated when the trigger is released