Manual

64 GEO3.5 MANUAL
SYMPTOM POSSIBLE CAUSE SOLUTION
The GEO3.5 is chopping or trapping paint
The break beam sensor system is dirty causing the
incorrect detection of paintballs
Clean the break beam sensor system
Incorrectly seated rubber bolt tip Re-seat the rubber bolt tip
Damaged rubber bolt tip Replace the rubber bolt tip
The GEO3.5 has low velocity on the rst shot
The FSDO parameters are set too low to overcome
o-ring stiction
Adjust FSD COMP and FSD DLY parameters
The GEO3.5 has high velocity on the rst shot
The FSDO parameters are set too high Adjust FSD COMP and FSD DLY parameters
The inline regulator output pressure is creeping
Strip, clean and maintain inline regulator
Replace inline regulator Piston if necessary
GEO3.5 has velocity drop-off during rapid re
The battery is poor quality or has insufcient power
Use an Alkaline or metal hydride battery. Do not use
a low quality or rechargeable battery
The Solenoid Flow Restrictor (SFR) is set too low Increase the ow through the SFR
Air system/regulator does not ow fast enough to
keep up
Try another air system/regulator and replace as
necessary
Sticky/over lubricated o-rings in bolt assembly
Clean, re-lubricate and replace o-rings on bolt
assembly as necessary
Blocked body lter Clean / replace the body lter as necessary
Solenoid poppet is sticking from debris or too much
grease
Clean and lightly grease the solenoid poppet
Poorly maintained inline regulator Strip, lubricate and rebuild inline regulator
Constant low velocity The SL4 inline regulator is set too low
Increase the output pressure of the SL4 inline
regulator