Manual

60 GEO3.5 MANUAL
CONTINUED
Clean and check the condition of the single internal 005 NBR90 o-ring in the front
of the POPS insert, replace if necessary (see gure 26I). Lubricate this o-ring
liberally using Eclipse Grease.
Lubricate the narrow end of the POPS pin with a smear of Eclipse Grease and
push the pin, narrow end rst, into the POPS insert so that it sits in the POPS
insert and pokes through to the front (see gures 26J& 26K).
Screw the POPS insert back into the POPS body ensuring that the o-ring end
goes in rst (see gure 26G).
Replace the push rod into its designated slot (see gure 26L), then side a 004
NBR70 o-rings on both ends of the push rod. Make sure the push rod is centred
in the POPS body (see gure 26M).
Slide the bonnet over the POPS body and align the hole on the bonnet with the
front hole on the POPS body (see gure 26N).
Ensure the spring is on the latch button then slide them both into the POPS body
through the hole in the bonnet, spring end rst, making sure the latch button
pokes out the right side of the bonnet (see gure 26O).
Push the button down as far as it will go, then (while still holding down the button)
slide the bonnet back until the button engages with the POPS body and cannot
slide into the forward position (see gure 26P).
You have now successfully cleaned and maintained the Push On Purge System.
WARNING!
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
FIG 26I
FIG 26K
FIG 26M
FIG 26O
FIG 26J
FIG 26L
FIG 26N
FIG 26P