Manual

58 GEO3.5 MANUAL
CONTINUED
Lastly inspect and clean the large solenoid gasket, replacing if damaged
(see gure 25M).
Apply a small amount of grease to the outer most groove surrounding the
solenoid manifold pocket in the GEO3.5 body. Then making sure the top solenoid
manifold gasket lies at in the solenoid manifold, insert the solenoid manifold
back into the GEO3.5 body (see gure 25N).
Next place the solenoid gasket over the solenoid manifold ensuring that the
gasket is secure in its groove in the GEO3.5 body (see gure 25O). Make sure
that the bottom solenoid manifold gasket is at in its groove in the solenoid
manifold.
Place the solenoid valve over the solenoid manifold (see gure 25P),
making sure the location holes line up with the threads in the GEO3.5 body
(see gure 25Q).
Replace the retaining screws which hold the solenoid onto the GEO3.5 using
a 5/64” hex key (see gure 25R). DO NOT over tighten screws in the solenoid
assembly.
Maintenance of the solenoid assembly is complete.
WARNING!
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
FIG 25M
FIG 25O
FIG 25Q
FIG 25N
FIG 25P
FIG 25R