Manual

GEO3.5 MANUAL 57
CONTINUED
Check the underside of the solenoid valve to ensure that it is free from damage or
debris (see gure 25F).
The solenoid manifold has two gaskets, the top gasket
A
and the bottom gasket
B
as illustrated in gure 25G. Carefully remove both gaskets from the solenoid
manifold. Inspect and clean the top and bottom gaskets and the solenoid
manifold, replacing any damaged components.
1
Using a small size hex key or at headed screw driver, gently push the poppet
and cap out of the solenoid manifold (see gure 25H). Inspect and clean the
poppet, paying particular attention to the condition front face and o-rings
(see gure 25I). If either is damaged or worn, the poppet will need replacing.
Reinsert the poppet into the solenoid manifold in the orientation shown in
gure 25J. Then insert the cap, ensuring that it is rmly held in the solenoid
manifold.
Replace the top and bottom gaskets into their respective grooves in the solenoid
manifold as shown in gures 25K and 25L. Applying a small amount of Eclipse
Grease to the surface of the solenoid manifold and gaskets.
1 If the solenoid manifold is damaged remember to remove the poppet and cap before disposing
of the solenoid manifold.
FIG 25G
FIG 25I
FIG 25K
FIG 25H
FIG 25J
FIG 25L
WARNING!
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
A
B