Manual

GEO3.5 MANUAL 55
CONTINUED
Position the trigger so that the hole through the trigger lines up with the holes in
the bearing carrier, slide the trigger pin into place (see gure 24G).
Gently lower the trigger assembly and bearing carrier into the frame, taking
care not to damage the micro-switch or the OPTO sensor, and ensuring that the
trigger is positioned correctly (see gure 24H).
Using a 5/64” hex key screw the right side M2.5x5 retaining screw into place but
do not fully tighten it into place (see gure 24I).
Ensure the trigger moves freely within the frame, then using a 1/16” hex key
tighten down the trigger pin retaining set screw.
Place the trigger spring over the bearing carrier in its designated groove, align
the hole in the trigger spring with the front/left hole in the bearing carrier, then
screw the retaining screw into the frame. Tighten both screws with a 5/64” hex
key (see gure 24J).
DO NOT over-tighten the retaining screws. Doing so may damage the trigger
spring and threads in the frame.
You have now stripped and cleaned your GEO3.5 trigger assembly.
WARNING!
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
FIG 24G
FIG 24H
FIG 24I
FIG 24J