Manual

52 GEO3.5 MANUAL
ATTACHING THE FRAME
To install the frame, rstly check the SFR seal is correctly located in the top of the
frame (see gure 22A), then carefully thread the solenoid and the Break Beam Sensor
System wiring harnesses through the access hole in the top of the frame and line the
frame up so that the rear frame screw sits in the access hole (see gure 22B).
Be careful not to trap or pinch the BBSS or solenoid wires between the body and
frame.
Slide the frame forward so that it sits completely ush with the GEO3.5 body and
using the short arm of a 1/8” hex key, tighten the rear frame screw into place
(see gure 22C). Check that no wires are trapped before tightening down the rear
frame screw.
Once the rear frame screw is secure, insert a 1/8” hex key into the front frame screw
hole in the foregrip crown and tighten the front screw into place (see gure 22D).
Connect the solenoid and Break Beam Sensor System wiring harnesses to their
respective ports on the GEO3.5 circuit board and (see gure 22E). Adjust the wires so
that they sit neatly in the grip frame and ensure that the wires do not obstruct either the
micro-switch or the OPTO sensor (see gure 22F).
Attach the GEO3.5 rubber grips to the frame using a 5/64” hex key to replace the four
grip screws (see gure 22G).
Screw the inline regulator back into the Front Regulator Mount and connect any hosing
that was disconnected earlier (see gure 22H).
You have now re-installed the frame onto the GEO3.5.
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
FIG 22A
FIG 22C
FIG 22E
FIG 22G
FIG 22B
FIG 22D
FIG 22F
FIG 22H