Manual

48 GEO3.5 MANUAL

MAINTAINING THE

BOLT SYSTEM

The GEO3.5 comes with two bolts. A soft nosed ST3 Bolt and an all metal ST Bolt

(see page 72).

To install the ST bolt follow the maintenance procedure below, swapping over the

bolts.

After installation, re-chronograph the GEO3.5 and adjust the SL4 inline regulator

accordingly.

Push the bolt bonnet up, unlocking the bolt system (see gure 19A). With the bolt

bonnet disengaged pull the entire bolt system out of the GEO3.5 body (see gure

19B).

Unscrew and separate the propshaft and bolt can sub-assemblies (see gure 19C).

Then push the bolt out of the back of the bolt can.

You should now have the following parts from the marker body: the bolt part

, the

bolt can part

and the prop shaft assembly

(see gure 19D).

Take the bolt can and having cleaned off any old grease, paint or debris, apply a

small amount of Eclipse Grease to the internal o-ring and the two external o-rings

(see gure 19E & 19F)

WARNING!

Always de-gas your marker, discharging any stored gas in a safe direction,

and remove the barrel, loader, air system and any paintballs to make the

marker easier and safer to work on.

Always check the shooting velocity of the GEO3.5 with a chronograph

before using the marker.

WARNING

FIG 19A

FIG 19C

FIG 19E

FIG 19G

FIG 19B

FIG 19D

FIG 19F

FIG 19H