Manual

GEO3.5 MANUAL 45

CONTINUED

FIG 16I

FIG 16K

FIG 16M

FIG 16J

FIG 16L

FIG 16N

FIG 16O

WARNING!

If you are unsure about performing a maintenance procedure please

contact your nearest service centre.

WARNING

Inspect the internal sealing surfaces of the regulator body, removing any dirt or

debris with a cotton bud (see gure 16J).

Re-install the adjuster assembly into the inline regulator body threaded end rst.

Apply light pressure to the top of the adjuster, while using a 1/8” hex turn the

adjuster screw counter-clockwise until is stops at the base of the inline regulator

body (see gure 16K).

Take the piston, inspect for damage and clean the 14x2 NBR70 o-ring at the top.

Re-lubricate it with a light application of Eclipse Grease (See Figure 16l). Place

the inline regulator spring over the piston, then insert the piston and spring into

the top of the inline regulator body (see gure 16M).

To replace the foregrip crown, push the crown up onto the body until the FRM

threads and body plug are covered (see gure 16N).

Re-attach the inline regulator to the GEO3.5 FRM (see gure 16O), then re-

connect the gas pipe tting (see page 15).

Basic cleaning of the SL4 inline regulator is complete.

Reset the input pressure to the factory default before supplying the GEO3.5 with

compressed air.

1 If any o-rings are damaged then replace them. Extra o-rings are available in parts kits available at