Manual

44 GEO3.5 MANUAL
THE SL4 INLINE
REGULATOR ASSEMBLY
Unscrew and remove the gas pipe assembly from the SL4 inline regulator (see gure
16A). See page 15 for more information on removing the gas pipe assembly.
Grip the SL4 inline regulator tightly through the rubber sleeve and unscrew the SL4
inline regulator from the GEO3.5 body (see gure 16B). Pull the foregrip crown down
to free it from the GEO3.5 body (see gure 16C).
Inspect the o-ring at the top of the threads on the FRM for damage (labelled
A
gure 16D). Replace and re-lubricate as necessary.
1
Tip both the piston and spring out of the top of the inline regulator (see gure 16E).
Insert a 1/8” hex key into the adjuster screw assembly in the bottom of the inline
regulator, turn the adjuster screw clockwise through the inline regulator body (see
gure 16F & 16G), and push the adjuster assembly out of the top of the inline
regulator body.
2
Thoroughly clean the 011 NBR70 o-rings that sits on the outside of the adjuster
assembly, then re-lubricate with Eclipse Grease (see gure 16H).
1
Using a dry cotton bud, clean the internal 008 NBR70 o-ring that sits inside the top
section of the adjuster top. Then using a small hex key gently apply Eclipse Grease
to the o-ring (see gure 16I).
1
1 If any o-rings are damaged then replace them. Extra o-rings are available in parts kits available at
www.planeteclipse.com.
2 The adjuster screw can only be removed by turning it upwards through the bottom section of the
inline regulator. The regulator will be damaged if the adjuster screw is removed incorrectly.
FIG 16A
FIG 16C
FIG 16E
FIG 16G
FIG 16B
FIG 16D
FIG 16F
FIG 16H
A
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
WARNING