Manual

GEO3.5 MANUAL 43
WARNING!
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
CONTINUED
Remove the rubber detent and using a dry cotton bud clean the detent and
its location point in the GEO3.5 body, replacing the detent if it is damaged
(see gure 15D).
Reinsert the detent back into the GEO3.5 body and place the BBSS back into the
designated slot in the body (see gure 15E). Ensure that the sensor is face down
in the body i.e. looking into the breech.
1
Replace the eye cover and using a 5/64” hex key, replace the retaining screw to
hold the eye cover in place (see gure 15F).
Repeat the procedure for the opposite side of the GEO3.5.
You have now cleaned your Break Beam Sensor System.
1 Ensure that the receiver sensor (indicated by a red mark & red heat shrink) is located on the right-
hand side of the marker body.
FIG 15D
FIG 15E
FIG 15F