Manual
30 GEO3.5 MANUAL
FIRE MODE PARAMETER
This parameter is used to select the ring mode of the GEO3.5 and has the following choices:
> SEMI: This is the default and in this ring mode the GEO3.5 will re one shot for every trigger pull.
> RAMP: In this ring mode, the rate of re is increased above the rate at which the trigger is pulled once certain criteria
have been met. These criteria are set by the parameters on the Ramp Setup menu.
1
> CANCEL: Editing is cancelled and the parameter is unchanged.
1 Some pre-sets and re modes may only be available in certain countries and on some models of the GEO3.5.
ROF CAP PARAMETER
The ROF CAP parameter is used to specify whether or not the GEO3.5 should have a limited / capped rate of re. When the
ROF CAP is enabled (and the BBSS is enabled), the maximum achievable rate of re is set by the BS ON ROF parameter.
Choices for the ROF CAP parameter are:
> OFF: Rate of re only limited by the loader.
> ON: Rate of re limited to the BS ON ROF parameter value.
> CANCEL: Cancel editing and leave the parameter unchanged.
At the bottom of the parameter screen the unit for that parameter will be displayed. Some parameters will not have units,
such as on or off parameters.
BS ON ROF PARAMETER
The BS ON ROF parameter is used to set the maximum achievable rate of re from the GEO3.5. The value of this parameter
can be adjusted between 4.0 and 30.0 balls per second in 0.1bps increments.
1
The BS ON ROF parameter will only be displayed if you have set the ROF CAP parameter to ‘ON’.
1 Always calibrate your GEO3.5 ROF CAP parameters to the local eld BPS meter as readings may vary from meter to meter.
BS OFF ROF PARAMETER
The BS OFF ROF parameter is used to control how fast the GEO3.5 cycles when the Break Beam Sensor System is
disabled. This parameter can be set between 4.0 and 15.0 balls per second and should always be set to the slowest speed
of the loading system in use.
1
1 Always calibrate your GEO3.5 ROF CAP parameters to the local eld BPS meter as readings may vary from meter to meter.