Manual

GEO3.5 MANUAL 23
THE AUX OUT INDICATOR
The auxiliary socket on the GEO3.5 circuit board allows third party products such
as loaders or RF transmitters to be interfaced to the GEO3.5.
The AUX out indicator is turned on and off via the AUX OUT parameter (see page
39). There are two possible conditions that can be indicated:
THE BBSS INDICATOR
The BBSS is able to switch itself off in the event of a blockage or contamination
preventing it from functioning correctly. In this instance, the BBSS will switch itself
back on once the blockage is cleared and the correct operation can be resumed.
The BBSS indicator on the main screen is used to indicate the eight possible
states of the BBSS as follows:
BBSS Enabled and ball detected
The GEO3.5 can be red at the maximum rate of re determined by
the chosen ring mode.
BBSS Fault has been cleared and ball detected
The system has been re-enabled. A ball is detected and the GEO3.5
can be red at the maximum rate of re determined by the chosen
ring mode.
BBSS Disabled
The GEO3.5 can be red at a maximum rate of re as set by the BS
OFF ROF parameter (see page 30).
BBSS Enabled in training mode
The BBSS has been over-ridden as the user has selected training
mode. As the user has chosen to leave the BBSS on, the achievable
rate of re is limited by the ring mode.
BBSS Enabled no ball detected
The GEO3.5 cannot be red.
BBSS Fault has been cleared and no ball detected
The system has been re-enabled. No ball is detected so the GEO3.5
cannot be red. To reset the BBSS icon, use the button to switch
off the BBSS and then back on again.
BBSS Fault detected
The system is disabled. The GEO3.5 can only be red at a maximum
rate of 2 bps less than the maximum rate of re, up to a maximum of
10 bps.
BBSS Disabled in training mode
The BBSS has been over-ridden as the user has selected training
mode. As the user has chosen to turn the BBSS off, the achievable
rate of re is limited by the BS OFF ROF parameter (see page 30).
AUX Out enabled
The AUX OUT is enabled. Each time the circuit board detects a valid
trigger pull a signal will be sent to the AUX connector on the circuit
board.
AUX Out disabled
The AUX OUT is disabled. No signal will be sent to the AUX
connector on the circuit board.