Manual

20 GEO3.5 MANUAL
UNLOADING THE GEO3.5
WARNING!
Always keep the Eclipse GEO3.5 pointed in a safe direction and ensure
all persons within range continue to wear face protection, until marker is
completely unloaded and safe.
WARNING
Securely attach a barrel blocking device such as the Eclipse Barrel Sock
1
(supplied with the GEO3.5) to the marker as shown in Figure 13A.
Turn off the GEO3.5 electronics by holding down the button on the back of the
frame. When the screen turns off and the marker speaker emits the ‘off’ tone (if
the SOUND parameter is enabled), the marker has been turned off (see gure
13B).
With the GEO3.5 pointing away from you. De-gas the marker by depressing the
POPS latch button allowing the bonnet to slide forward and vent air. Only when
the POPS has fully degassed the GEO3.5 marker, unscrew and remove the air
system (see gure 13C).
Open the clamping lever on the feed tube and slacken off the sprocket screw
if necessary on the feed tube. Carefully pull the loader out of the feed tube (see
gure 13D).
Looking down the feed tube, check to see if there are any paintballs still in the
breech, if there are, turn the marker upside down while still keeping the barrel
facing away from any persons within ring range then tip out any paintballs within
the breech (see gure 13E & 13F).
Next remove the barrel blocking device, and unscrew the barrel (see gure 13G).
Remove any paintballs within the barrel. The Eclipse GEO3.5 has now been
unloaded and is ready for storage.
1 Instruction on using the Eclipse barrel sock can be found on the Eclipse barrel sock warning label.
FIG 13E
FIG 13C
FIG 13A
FIG 13G
FIG 13D
FIG 13B
FIG 13F