Manual

18 GEO3.5 MANUAL
VELOCITY ADJUSTMENT
+
_
When using your GEO3.5, you may wish to change the velocity at which your
GEO3.5 is ring. This is done by inserting a 1/8" hex key into the adjuster screw
at the bottom of your GEO3.5 inline regulator and adjusting it accordingly (see
Figure 11A). By turning this adjuster screw clockwise you decrease the output
pressure of the inline regulator and consequently the velocity; by turning the
adjuster screw counter-clockwise you increase the output pressure of the inline
regulator and consequently the velocity. On the bottom of the inline regulator
sleeve there are arrows to illustrate which direction to turn the hex key to make
the relevant adjustment.
1,2,3
1 After each adjustment re two clearing shots to gain an accurate velocity reading.
Never exceed 300fps.
2 High, mid and low pressure output pre-set air systems can be used with the GEO3.5,
providing the GEO3.5 has the SL4 inline regulator originally supplied with the marker.
3 Turning the SL4 adjuster screw in too far will prevent the GEO3.5 from ring.
FIG 11A