Manual

16 GEO3.5 MANUAL
INSTALLING A
PRE-SET AIR SYSTEM
WARNING!
• Make sure the marker is turned off with a barrel blocking device installed
and that no paintballs are in the marker or loader before installing an air
system.
• Compressed air and nitrogen systems can be extremely dangerous if
handled or used incorrectly.
• Only use an air system certied for use within the territory of intended use.
• The GEO3.5 cannot be used with CO2. Only USE compressed air or
nitrogen.
• Never add any lubricants or greases into the ll adapter of the air system
regulator.
• Ensure that all screws are tightened and no parts are loose before installing
an air system.
• Do not pressurise the GEO3.5 without the bolt system correctly installed, as
high pressure gas will be released.
• Do not install a compressed air system or load paintballs into the GEO3.5
until you feel completely condent with your ability to handle the marker
safely and responsibly.
• Always relieve all residual gas pressure from the GEO3.5 before
unscrewing the pre-set air system.
WARNING!
Check that the gas through pipe assembly is correctly installed
before installing a pre-set air system.
See page 15 for instructions on installing the gas through pipe
assembly.
If you are at all unsure about installation of the gas through pipe
please contact your nearest service centre.
WARNING
WARNING