Manual

14 GEO3.5 MANUAL
ATTACHING A LOADER
WARNING!
Do not over tighten the clamping feed tube as this may damage the loader
or feed tube itself.
Paintball industry standard eye/face/ear and head protection designed
specically to stop paintballs and meeting ASTM standard F1776 (USA)
or CE standard (Europe) must be worn by the user and any person within
range during use, assembly, cleaning and maintenance at all times.
WARNING
Using a 5/32” hex key or your ngers, turn the sprocket screw of the clamping
feed tube counter-clockwise (see gure 8A).
Release the clamping lever on the feed tube (see gure 8B) and test to see
if your loader can easily be pushed into the top of the feed tube. If the loader
cannot easily be pushed into the feed tube, loosen the sprocket screw of the
clamping feed tube a little more by turning it counter-clockwise using a 5/32” hex
key or your ngers (see gure 8A).
When you have managed to push your loader into the clamping feed tube, close
the clamp to secure it rmly in place (see gure 8C). If the loader is loose then
you will need to release the clamp, tighten the sprocket screw slightly by turning
it clockwise with a 5/32” hex key or your ngers and close the clamp. Repeat this
process as necessary to secure your loader in place.
You have now attached a loader to your GEO3.5. Once you have lled your
loader and air tank you will then be ready to begin using your GEO3.5.
FIG 8A
FIG 8B
FIG 8C