Manual

TheBreakBeamSensorSystem,referredtoelsewhereinthismanual
as‘BBSS’isusedtodetectwhenapaintballisreadytobefired
fromtheGEO3.1.IfnopaintballisreadythentheBBSSwillinhibit
theGEO3.1fromfiring.ThispreventstheGEO3.1from“chopping”
paintballsthatarenotfullyloadedintothemarker.
1


ToswitchofftheBBSS,pressandholdthe
buttonfor0.5seconds
(SEEFIGURE4A) .TheBBSSindicatoronthetoprightoftheLCDwill
changefrom
(enabled)to (disabled).

ToswitchtheBBSSbackon,pressandholdthe
buttonfor0.5
second.Theindicatorwillchangebackto
.

WhentheBBSSisenabled,theindicatorwillchangedepending
uponwhetherthesystemhasdetectedaballornot.Whennoball
hasbeendetectedtheindicatorwilllooklikethis
.Whenaballhas
beendetectedtheiconchangestolooklikethis
.

AdditionalfeaturesoftheGEO3.1’sBreakBeamSensorSystemare
coveredinfullonpage23ofthisoperatorsmanual.















1
When the GEO3.1 is turned on, the BBSS is automatically enabled.
USiNG THE BREAK BEAM
SENSOR SYSTEM
FIG4A
USiNG THE GEO3.1 9