Manual

EnsurethattheGEO3.1isswitchedoff.Laythemarkeronaflat
surfaceinfrontofyouwiththefeedtubefurthestawayandwiththe
barrelpointingtotheright.
Usea5/64”(2mm)hexkeytoremovethetwocountersunkscrews
thatholdtherubbergripontotheframe
(SEEFIGURE2A) .Peelthegrip
totherighttoexposethecircuitboardwithintheframe.
Removethefittedbatterybyslidingyourthumborfingerintothe
recessbelowthebatteryandleveringthebatteryoutoftheframe
(SEEFIGURE2B) .
DONOTpullonthetopofthebatterytoremoveitasthiscancause
thebatteryterminalstobendandwillresultinapoorelectrical
connection.
Fita9-voltalkalinebattery(typePP3,6LR61orMN1604)intothe
recesswiththebatteryterminalsawayfromyou.Thepositive
terminalshouldbeontherighthandside,nearesttothefrontsideof
theframe
(SEEFIGURE2C) .
PlanetEclipserecommendsusingabrandedhighqualityalkaline9V
battery.Budgetandrechargeablebatteriesmaycauseperformance
issues.

Ensurethatallofthewiresarewithintherecessoftheframeand
awayfromthetrigger,micro-switchandOPTOsensorssoasnotto
interferewiththeiroperation.Replacetherubbergripandscrewin
thetwocountersunkscrews.
DONOTOVER-TIGHTENTHEGRIPSCREWS.
iNSTALLiNG A 9V BATTERY
FIG2A
FIG2B
FIG2C
USiNG THE GEO3.1 7