Manual

TheGEO3.1ischoppingortrappingpaint.

TheGEO3.1haslowvelocityonthefirstshot.


TheGEO3.1hashighvelocityonthefirst
shot.


GEO3.1hasvelocitydrop-offduringrapid
fire.
Constantlowvelocity.
GEO3.1triggerisvery“bouncy”.
Thebreakbeamsensorsystemisdirty
causingtheincorrectdetectionofpaintballs.
solenoid.

Incorrectlyseatedrubberbolttip.
Damagedrubberbolttip.
TheFSDOparametersaresettoolowto
overcomeo-ringstiction.

TheFSDOparametersaresettoohigh.
Theinlineregulatoroutputpressureis
creeping.
Thebatteryispoorqualityorhasinsufficient
power.
TheSFRissettoolow.
Airsystem/regulatordoesnotflowfast
enoughtokeepup.
Sticky/overlubricatedo-ringsinbolt
assembly.
Blockedbodyfilter.
Solenoidpoppetisstickingfromdebrisortoo
muchgrease.
Poorlymaintainedinlineregulator.
TheSL4inlineregulatorissettoolow.
Incorrectfiltersettings.
Cleanthebreakbeamsensorsystem.



Re-seattherubberbolttip.
Replacetherubberbolttip.
AdjustFSDCOMPandFSDDLYparameters.

AdjustFSDCOMPandFSDDLYparameters.

Strip,cleanandmaintaininlineregulator.

UseanAlkalineormetalhydridebattery.Do
notusealowqualityorrechargeablebattery.
IncreasetheflowthroughtheSFR.
Tryanotherairsystem/regulatorandreplace
asnecessary.
Clean,re-lubricateandreplaceo-ringson
boltassemblyasnecessary.
Clean/replacethebodyfilterasnecessary.
Cleanandlightlygreasethesolenoidpoppet.
Strip,lubricateandrebuildinlineregulator.
IncreasetheoutputpressureoftheSL4inline
regulator.
Checkthatyourtriggerfilteranddebounce
settingssuityourtriggerset-up.
SYMPTOM POSSIBLE CAUSE SOLUTION
64 FAULT FiNDiNG