Manual

TheGEO3.1degassesveryslowly.
TheGEO3.1leaksfromthesolenoid
assembly.








GEO3.1leaksdownthebarrel.




Gasventsquicklydownthebarrelassoonas
theGEO3.1isgassedup.

TheGEO3.1ischoppingortrappingpaint.
Thebodyfilterisblocked/damaged.
Checkthatthethreesolenoidgasketsare
intactandseatedintheirdesignatedpockets
bothinandaroundthesolenoidmanifold.
GEO3.1solenoidassemblyisover-
pressurising.
Debrison/damagetopoppet.
DamagedGEO3.1solenoidvalve.
Frontorrearpropshaft14x2NBR70o-rings
aredamaged,dirtyordry.
Internal017NBR70o-ringandexternal020
NBR70o-ringsonboltcanaredamaged,dry
ordirty.
Theboltisstuckinaforwardposition.
Mainpropshaft014x2o-ringisdamagedor
anincorrectsize.
Theloaderhastoohighaforcefeedsetting.
Poorqualitypaintballs.
Thebreakbeamsensorsystemisswitched
off.
Theboltisdirtycausingtheincorrect
detectionofpaintballs.
Cleanthebodyfilterandinspectfordamage.
Replaceifdamaged.
Replaceanyofthesolenoidgasketsifthey
aredamaged.

Checktheinlineregulatoroutputpressure
andconsequentvelocity.Adjustaccordingly.
StripandcleantheSL4inlineregulator.
Replacingthesealsasnecessary.
Clean/replacethepoppet.
ReplacetheGEO3.1solenoidvalve.
Replace,cleanandlubricate14x2NBR70
o-ringsonpropshaft.
Replace,cleanandlubricate017NBR70
o-ringand020NBR70o-ringsonthebolt
can.

Pushtheboltbackwards.
Replacewithanew014x2sizeo-ring.

Adjusttheloadertoalowerforcefeed
setting.
Usebetterqualitypaintballs.
Switchonthebreakbeamsensorsystem.

Cleantheboltandbreach.
SYMPTOM POSSIBLE CAUSE SOLUTION
FAULT FiNDiNG 63