Manual

Althoughafreshbatteryhasbeenfitted,the
GEO3.1willnotswitchon.
Thebatterydoesnotseemtolastverylong.

TheGEO3.1doesnotfire.
Thebatteryhasbeenfittedincorrectly.
Thebatteryhasdrainedontheshelf.
Thebatteryterminalsarenotmakingproper
contactwiththebattery.
Thebatterytypeisofalowquality.
ThePOPSisnotengaged.
Solenoidflowrestrictor(SFR)settoolow.
TheSFRassemblyisblocked.
Batteryqualityorlevelofchargeisverylow.
Thebatteryisflat.
TrainingModeisenabled.
Triggerandtriggerdetectionmethodareset
upincorrectly.
Triggerdetectionsystemisblocked.
Thesolenoidassemblyisnotpluggedinto
GEO3.1PCBcorrectly.
Thebreakbeamsensorsystemisenabled
buttherearenopaintballsinthebreech.

Fitthebatterycorrectlywiththepositive
terminalnearesttothesideoftheframe.
Replacewithanotherfreshbattery.
Removethebattery,gentlybendthe
terminalstowardswherethebatterywillsit
andthenreplacethebattery.

Useanalkalineormetalhydridebattery.Do
notusealowqualityorrechargeablebattery.
EngagethePOPSfully.
IncreasetheflowthroughtheSFR.
StripandcleantheSFRassembly.
Installnewhighqualitybattery.
Installnewhighqualitybattery.
Disabletrainingmode.
Setupthetriggercorrectly(referto“Setting
thetrigger”section).

Removeanywiresordebrisfromthetrigger
detectionsystem.
Plugsolenoidassemblyplugintothesolenoid
portontheGEO3.1PCB.

Filltheloaderwithpaint/turnonloader.


POSSIBLE CAUSE SOLUTIONSYMPTOM
TheFaultFindingguidecoverscommonsymptoms,causesandsolutionsthatarelikelytobeencounteredbytheaverageuser.Ifanissue
withtheGEO3.1cannotbesolvedusingtheFaultFindingguide,contactyournearestEclipseServiceCentreforassistance.
FAULT FiNDiNG 61