Manual

BeforeusingtheGEO3.1itisimportanttomakesuretheSL4
inlineregulator,solenoidflowrestrictor(SFR)andallelectronically
controlledparametersaresetcorrectly.Allofthesecanhavea
negativeeffectontheperformanceofthemarkerifsetincorrectly.

ThestepsbelowwillrestoretheGEO3.1settingstothefactory
settings.ThesesettingswillgivetheGEO3.1amorebalanced
performance,idealfortheaverageuser.

INLINEREGULATOROUTPUTPRESSURE
Checktheinlineregulatoradjusterscrewissetto4
1/2
turnsclockwise
fromitsmaximumoutposition (SEEFIGURE1A) .Thiswillensurethe
SL4inlineregulatorissettoanoutputpressurethatwillnotdamage
theGEO3.1whensuppliedwithcompressedair/nitrogen(seepage
18formoreinformationonSL4inlineregulatoradjustment).

SOLENOIDFLOWRESTRICTORSETTINGS
Checkthatthesolenoidflowrestrictor (SEEFIGURE1B) issetas
pictured.Seepage19formoreinformationonthesolenoidflow
restrictor.

ELECTRONICALLYCONTROLLEDPARAMETERS
LoadtheFACTORYpreset (SEEFIGURE1C) storedontheGEO3.1
circuitboard.Thispresetwillrestorealltheelectronicparametersto
theirdefaultsettings.Seepage29onloadingtheFACTORYpreset.
FACTORY SET-UP GUiDE
FIG1A
FIG1B
FIG1C
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
6 USiNG THE GEO3.1