Manual

THEREISNONEEDTOREMOVETHEPOPSFROMTHEGEO3.1
FRAMEFORGENERALMAINTENANCE.IFTHEPOPSISREMOVED,
ENSURETHEO-RINGISCORRECTLYSEATEDBEFOREPOPSRE-
ATTACHMENT.

Fullydepressthelatchbuttonthenslidethebonnetforwardwhile
continuingtodepresslatchbutton
(SEEFIGURE26A) .
Whenthebonnetisintheforwardposition
(SEEFIGURE26B) remove
thelatchbuttonandspringfromthebonnet (SEEFIGURE26C) then
slidethebonnetoffthePOPSbody (SEEFIGURE26D) .Becarefulnotto
losethespring.
CarefullyslidethepushrodoutfromeithersideofthePOPSbody,
takingcarenottolosethetwoo-ringsonthepushrod (SEEFIGURE
26E) .
Cleanoffanydirt,debrisormoisturefromthebonnet,thePOPS
bodyandthelatchbutton
(SEEFIGURE26F) .
RemovethePOPSinsertassemblyusinga5/32”hexkey
(SEEFIGURE
26G)
.RemovethePOPSpinfromthePOPSInsert.
Cleanandchecktheconditionofthe007NBR70o-ringonthe
outsideofthePOPSinsert,replacingasnecessary
(SEEFIGURE26H) .
THE PUSH ON PURGE
SYSTEM (POPS)
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG26A
FIG26C
FIG26E
FIG26G
FIG26B
FIG26D
FIG26F
FIG26H
MAiNTENANCE 59