Manual

***IMPORTANT***
TheGEO3.1solenoidassemblycontainstwosub-assemblies,the
solenoidvalveandthesolenoidmanifold.Removalofthesolenoid
valveisrequiredtoaccessthesolenoidmanifoldforservicing.The
solenoidvalveitself
(SEEFIGURE25A) isanon-serviceableitem.Any
attempttostriporservicethesolenoidvalvewillimmediatelyvoid
theGEO3.1warranty.IfyouexperienceanyissuewiththeGEO3.1
solenoidvalvethenpleasecontactyourEclipseServiceCentre.See
page66forEclipseServiceCentredetails.

WiththeframeseparatedfromtheGEO3.1bodyandthesolenoid
andBBSSwiresunpluggedfromthecircuitboard(seepage51)use
a5/64”hexkeytoundoandremovethetwoscrewsthatholdthe
solenoidassemblyontotheGEO3.1body
(SEEFIGURE25B) .

Firstlyremovethesolenoidvalvefromthebody,thiswillexposethe
solenoidmanifoldwhichsitspartiallyinsidetheGEO3.1body
(SEE
FIGURE25C) .

CarefullypullthesolenoidmanifoldoutfromtheGEO3.1body,
exposingthegastransferholeswhichleadtotheboltassembly
(SEE
FIGURE25D) .Thesolenoidgasketmaystillbeattachedtothebody,
ifthisisthecase,carefullypeelthegasketoffthebodyandplaceto
oneside.

WiththesolenoidassemblycompletelyremovedfromtheGEO3.1
body,thebottomoftheGEO3.1bodyshouldnowresemble
FIGURE
25E .Ensurethattheairtransferholesinthebottomofthebodyare
freefromcontaminationfromanydirt,debris,paintormoistureand
clearawayanyexcessgreaseifitappearstobeblockinganyofthe
transferholes.
THE GEO3.1 SOLENOiD
ASSEMBLY
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG25A
FIG25C FIG25D
FIG25B
FIG25E FIG25F
56 MAiNTENANCE