Manual

Thisprocedureisonlyrequiredifyouaremaintainingtherearprop
shaft14x2o-ring,whichifdamagedordirtywillcausealeakaround
thebackcapoftheGEO3.1.

Insertanappropriatelysizedhexkeyorscrewdrivershaftintothe
holeinthemiddleofthepropshaft,takea1/8”hexkeyandremove
theretainingscrewinthebackofthepropshaft
(SEEFIGURE20A) .
Removethepropshaftfromthebackcap,takingcarenottolose
thepropshaftspring.Checkthe14x2o-ringatthebackoftheprop
shaft,andcleanorreplacethenre-lubricatewithEclipseGreaseas
necessary
(SEEFIGURE20B) .

Checktherearbumperforsignsofwear,replaceasnecessarythen
re-installthespring
(SEEFIGURE20C) .Replacethebackcapoverthe
rearofthepropshaft,thenreplacetheretainingscrewusinga1/8”
hexkeytoreassembletopropshaft
(SEEFIGURES20D&20E) .
1















1
If any o-rings or the bumper are damaged then replace them. Extra o-rings and bumpers are
available in parts kits available at www.planeteclipse.com
ADVANCED BOLT SYSTEM
MAiNTENANCE
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG20A
FIG20B
FIG20C
FIG20D
FIG20E
50 MAiNTENANCE