Manual

Usinga1/4”hexkeyorfingersunscrewthepropshaftfromthe
markerbody (SEEFIGURE19A) .Oncethethreadedsectionisfreefrom
thethreadsinthemarkerbodyandturningfreely,pullthepropshaft
fromthemarkerbody.

Placeafingerdownthefeedtubeandpushtheboltintotheboltcan
insidethebodybypushingitbackwards
(SEEFIGURE19B) .Inserta
fingerintotherearofthemarkerandremovetheboltandboltcan
completely
(SEEFIGURE19C) .

Youhaveremovedthefollowingpartsfromthemarkerbody:the
propshaft
A
,theboltcan
B
andthebolt
C
 (SEEFIGURE19D) .

Taketheboltcanandhavingcleanedoffanyoldgrease,paintor
debris,applyasmallamountofEclipseGreasetothetwoexternal
o-rings
(SEEFIGURE19E) andtheinternalo-ring (SEEFIGURE19F)
1
.

SmearalightcoatofEclipseGreaseontothesmoothinternalboreof
theboltcanfromtherear
(SEEFIGURE19G)
1
.

Takethepropshaftandhavingcleanedoffanyoldgrease,paintor
debris,applyEclipseGreasetothelargerearo-ringandthethreads
(SEEFIGURE19H) .









1
Remove any excess blobs of eclipse grease from the inside and outside of the bolt can.
MAiNTAiNiNG THE BOLT
SYSTEM
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
B
C
A
FIG19BFIG19A
FIG19D
FIG19C
FIG19E
FIG19F
FIG19H
FIG19G
48 MAiNTENANCE