Manual

Inspecttheinternalsealingsurfacesoftheregulatorbody,removing
anydirtordebriswithacottonbud (SEEFIGURE16J) .

Re-installtheadjusterassemblyintotheinlineregulatorbody
threadedendfirst.Applylightpressuretothetopoftheadjuster,
whileusinga1/8”hexturntheadjusterscrewcounter-clockwiseuntil
isstopsatthebaseoftheinlineregulatorbody
(SEEFIGURE16K) .
Takethepiston,inspectfordamageandcleanthe14x2NBR70
o-ringatthetop.Re-lubricateitwithalightapplicationofEclipse
Grease (SEEFIGURE16L) .Placetheinlineregulatorspringoverthe
piston,theninsertthepistonandspringintothetopoftheinline
regulatorbody
(SEEFIGURE16M) .
1
Toreplacetheforegripcrown,pushthecrownupontothebodyuntil
theFRMthreadsandbodyplugarecovered (SEEFIGURE16N) .
Re-attachtheinlineregulatortotheGEO3.1FRM
(SEEFIGURE16O) ,
thenre-connectthegaspipefitting(seepage15).
BasiccleaningoftheSL4inlineregulatoriscomplete.

Resettheinputpressuretothefactorydefaultbeforesupplingthe
GEO3.1withcompressedair.






1
If any o-rings are damaged then replace them. Extra o-rings are available in parts kits available
at www.planeteclipse.com
(CONTiNUED)
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
FIG16I
FIG16J
FIG16K
FIG16M
FIG16O
FIG16L
FIG16N
MAiNTENANCE 45